When installing a blind, it is crucial that the blind is perfectly horizontal and level to prevent the fabric from tracking to the sides during operation. Failing to do so will damage the fabric and possibly the control mechanism too. In extreme cases the blind could jam up and fall down.
Noting which side the control will be, place the control bracket in place and secure it with adequate screws.
Place the pin end bracket in place and secure it with adequate screws. – If necessary, with a pencil make a small mark where your control bracket will be secured (This will be where the back of the bracket is) and measure the width of the blind to establish where your pin end bracket will be.
Place the motor head onto the control bracket tongue. (Ensuring the wire/s is not obstructing the motor from fully sliding onto the bracket).
Insert the pin end of the blind into the pin end bracket. (To remove the blind, simply rotate the flat, clear disk on the pin end. This will retract the pin into the mechanism and allow the blind to be taken down).
